IFM AC1309 handleiding
Handleiding
Je bekijkt pagina 10 van 23
Electrical connection
Disconnect the installation from power. Connect the unit as indi-
cated on the terminals. Never connect the minus potentials to
each other or the minus potentials to the FE connection. Ensure
an electrically save ground connection between AS-i controller
e
(terminal FE) and ground of the unit.
Supply the controller
e
with a 24V DC voltage (20 ... 30V PELV), e.g.
from the 24V power supply DN2011 of ifm electronic. The connection
is made to the terminals +24V and 0V.
Operating and indicating elements
Information concerning the state of the master (AC1305)/masters
/AC1306) and the connected system is given via three diagnostic LEDs
on the controller
e
.
• LED PWR/COM lights: AS-i voltage present, at least one slave
was detected
• LED PWR/COM flashes: AS-i voltage present, but no slave was
detected correctly
• LED PROJ lights: Projection mode active, the configuration
monitoring is deactivated
• LED PROJ flashes: Projection mode active, changeover to
protected mode not possible as a slave
with the address 0 is connected
• LED CONF/PF lights: Projected and current configuration do
not match
• LED CONF/PF flashes: Periphery fault on at least one connected
slave
Ethernet Status LEDs
• LED address state:
green flashing 1Hz: The IP address is freely selectable
red flashing 1Hz: invalid MAC ID (internal fault
Ethernet interface)
red flashing 2Hz: no valid Ethernet configuration
loaded
PAGE 10
Bekijk gratis de handleiding van IFM AC1309, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IFM |
| Model | AC1309 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1483 MB |
