IDIS DH-2010P handleiding
Handleiding
Je bekijkt pagina 19 van 22
19
Cascading
1
Connect the RJ-45 uplink ports of system 1 and system 2 using a UTP cable.
2
Check the RJ-45 uplink port SPD LED's status and verify that a normal connection has been
established between the two products.
If the PoE switch is not connected to network connection at 1000Mbps, the network bandwidth
may not be enough, and the NVR may not record video normally.
DirectIP™ PoE Switch
DirectIP™ PoE Switch
Port Connection Warnings and Tips
• Keep the UTP cable length to less than 100m (328 ft).
• Only use category 5 or higher UTP cables with RJ-45 connectors to connect to the system. The
system's ports can automatically distinguish between MID and MDIX connectors, so there is no
need to use a crossover cable when connecting to a dierent device's TX port.
• The system's RJ-45 uplink ports may be used as service ports, but they do not support PoE.
[RJ-45 Port Connection]
Bekijk gratis de handleiding van IDIS DH-2010P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IDIS |
| Model | DH-2010P |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1425 MB |
Caratteristiche Prodotto
| Kleur van het product | Zwart |
| Gewicht | 1350 g |
| Breedte | 280 mm |
| Diepte | 180 mm |
| Hoogte | 44 mm |
