Icron USB 2.0 Ranger handleiding
Handleiding
Je bekijkt pagina 16 van 21
PROBLEM CAUSE SOLUTION
Link LED on the
LEX and the REX
units are blinking
slowly.
•Theextendersarepairedwith
each other but have not yet
established a link.
1. Wait for a few minutes for the LEDs to go solid.
2. If LEDs do not go solid, contact your network
administrator to determine if any traffic is being
blocked between the extenders.
Link LED on the
LEX is on, Host LED
on the LEX is off.
•Thehostcomputerisnot
powered on.
•TheLEXisnotconnected
to the computer.
•Thehostcomputerisnot
recognizing the LEX.
•Thecomputerdoesnot
support USB hubs.
•TheRanger2304GE-LANis
malfunctioning.
1. Disconnect all USB devices from the REX.
2. Disconnect the LEX from the computer.
3. Disconnect the REX from the AC power adapter.
4. Reconnect the LEX to the computer.
5. Reconnect the REX to the AC power adapter.
6. In the Universal Serial Bus controllers section of
Device Manager, check that the Ranger
2304GE-LAN is recognized as a
“Generic USB Hub”.
My USB device
does not work
properly.
•Insufcientbandwidthis
available on the network to
support the device.
1. Connect the LEX and REX directly to each
other and try the USB device again.
My USB device
does not work at
all.
•Insufcientbandwidthis
available on the network to
support the device.
•TheLEXunitispairedto
the wrong REX unit.
1. Connect the LEX and REX units directly
to each other and try the USB device again.
2. Follow the instructions on page 11 and pair the
LEX to the REX units that is connected
to the device you wish to use.
15
Bekijk gratis de handleiding van Icron USB 2.0 Ranger, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Icron |
| Model | USB 2.0 Ranger |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2295 MB |
