Icron USB 2.0 Ranger 2301 handleiding
Handleiding
Je bekijkt pagina 16 van 21
PROBLEM CAUSE SOLUTION
Link LED on the
LEX and REX are
blinking slowly.
•Theextendersarepairedwith
each other but have not yet
established a link.
1. Wait for a few minutes for the LEDs to go solid.
2. If LEDs do not go solid, contact your network
administrator to determine if any traffic is being
blocked between the extenders.
Link LED on the
LEX is on, Host LED
on the LEX is off.
•Thehostcomputerisnot
powered on.
•TheLEXisnotconnectedto
the computer.
•Thehostcomputerisnot
recognizing the LEX.
•Thecomputerdoesnot
support USB hubs.
•Theextendersystemis
malfunctioning.
1. Disconnect the USB device from the REX.
2. Disconnect the LEX from the computer.
3. Disconnect the REX from the AC power adapter.
4. Reconnect the LEX to the computer.
5. Reconnect the REX to the AC power adapter.
6. In the Universal Serial Bus controllers section of
DeviceManager,checkthattheextendersystem
is recognized as a “Generic USB Hub”.
MyUSBdevice
does not work
properly.
•Insufcientbandwidthis
available on the network to
support the device.
1. Connect the LEX and REX directly to each other
and try the USB device again.
MyUSBdevice
does not work at
all.
•Insufcientbandwidthis
available on the network to
support the device.
•TheLEXispairedtothewrong
REX.
1. Connect the LEX and REX directly to each other
and try the USB device again.
2. Follow the instructions on page 11 and pair the
LEX to the REX that is connected to the device
you wish to use.
15
Bekijk gratis de handleiding van Icron USB 2.0 Ranger 2301, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Icron |
| Model | USB 2.0 Ranger 2301 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2262 MB |
