Icom IC-FR6100 handleiding
Handleiding
Je bekijkt pagina 10 van 16
7
2
INSTALLATION AND CONNECTIONS
■ Power supply connection
Make sure the repeater’s power is turned OFF when
connecting a DC power cable.
CAUTION: Voltages greater than 16 V DC will dam-
age the repeater. Check the source voltage before
connecting the power cable.
■ Mounting the repeater
D Using the supplied handle
The supplied handles are useful when mounting the
repeater into a 19 inch rack. The handles are installed
on the repeater’s front panel.
q Attach the supplied handles to both sides of the re-
peater’s front panel with the spacers, then tighten
the screws as shown below.
P
0
P
1
P
2
P
3
P
4
Handle
Spacer
Screw
w The completed installation should look like this.
P
0
P
1
P
2
P
3
P
4
■ Rear panel connection— For the IC-FR5100/IC-FR6100
CAUTION: NEVER remove the
fuse holders from the DC power
receptacle.
EXTERNAL SPEAKER
4 ˘ external speaker
Connects to a TX antenna
(p. 5)
Connects to an
RX antenna (p. 5)
ACC CONNECTOR
(p. 3)
Used for external
equipment control.
Connects to a dPMR
control unit, if used.
Blac
k
Red
20 A
fuses
DC power supply
AC outlet
AC cable
Supplied
DC power cable
13.2 V; at least 15 A
Black
_
Red
+
R When you disconnect the DC power cable, take
care to not break your fingernail.
q
Push
w
NOTE: The optional UR-PA5000/UR-PA6000
power amplifier units can be installed. See
the installation guide that comes with the
UR-PA5000/UR-PA6000 for details.
Bekijk gratis de handleiding van Icom IC-FR6100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Icom |
| Model | IC-FR6100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2186 MB |
