Ibiza Sound TBOX-QUAD4 handleiding
Handleiding
Je bekijkt pagina 3 van 36
Manual - TBOX-QUAD4
3
www.ibiza-light.com
EN
Always ensure that the unit is rmly xed to avoid vibration and slipping while operating. Always ensure that
the structure to which you are attaching the unit is secure and able to support a weight of 10 times of the unit’s
weight. Also always use a safety cable that can hold 12 times the weight of the unit when installing the xture.
The equipment must be xed by professionals at a place where is out of the reach of people and where nobody
can pass by or under it.
FUSE REPLACEMENT
• With a at head screwdriver wedge the fuse holder out of its housing.
• Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
• Insert the fuse holder back in its place and reconnect power.
• The fuse is located inside this compartment. Remove using a at head screwdriver.
FIXTURE LINKING
You will need a serial data link to run light shows of one or more xtures using a DMX-512 controller or to run
synchronized shows on two or more xtures set to a master/slave operating mode. The combined number of
channels required by all xtures on a serial data link determines the number of xtures that the data link can
support.
Console Light1 Light2 Light3
Important: Fixtures on a serial/data link must be daisy chained in one single line. Maximum recommended seri-
al data link distance: 100 meters. Maximum recommended number of xtures on a serial data link: 32 xtures
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
DMX CONNECTOR CONFIGURATION
INPUT
COMMON
DMX +
DMX-
Resistance 120 ohm
1/ 4w between pin 2
(DMX-) and pin 3
(DMX+) of the last
fixture.
Termination reduces signal errors. To avoid signal
transmission problems and interference, it is always
advisable to connect a DMX signal terminator.
CAUTION
Do not allow contact between the common and the xture’s chassis ground. Grounding the common can cause
a ground loop, and your xture may perform erratically. Test cables with an ohm meter to check correct polarity
and to make sure the pins are not grounded or shorted to the shield or each other.
HOW TO CONTROL THE UNIT
Access control panel functions using the four panel buttons located directly underneath the LCD Display.
Button Function
MENU Used to access the menu or to return to a previous menu option
UP Scrolls through menu options in ascending order
DOWN Scrolls through menu options in descending order
ENTER Used to select and store the current menu or option within a menu
When a menu function is selected, the display will show immediately the rst available option for the selected
menu function. To select a menu item, press <ENTER>.
Master mode: any unit cans work for master xture,
Slave mode: must be setting DMX address value for Slave.
DMX code setting: d1~d512
MANUAL SETTING MODE ON LED DISPLAY
Mode Display Description
DMX mode Addr 8CH d001-d512
4CH
4-1CH
UP
DOWN
MENU ENTER
8.8.8.8.
Bekijk gratis de handleiding van Ibiza Sound TBOX-QUAD4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Ibiza Sound |
| Model | TBOX-QUAD4 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 5829 MB |
