Iberna IDIN 1L38B-80 handleiding
Handleiding
Je bekijkt pagina 6 van 36
!
6
2. WATER CONNECTION
! The inlet and drain hoses can be directed
to left or right.
!
Water pressure must be between 0,08
MPa and 0,8 MPa.
!
The inlet hose must be connected to a tap
so that the water supply can be cut off
when the machine is not in use (fig. 1 B).
! The dishwasher is fitted with 3/4" threaded
connector (fig. 2).
! Connect inlet hose "A" to water tap "B"
with a 3/4" attachment making sure that it
has been properly tightened.
! If it is necessary, the inlet pipe can be
lengthened up to 2,5 m. The extension
pipe is available from the After Sales
Service Centre.
! If the dishwasher is connected to new pipes
or to pipes which have not been inuse for a
long time run water through for a few
minutes before connecting the inlet hose. In
this way no deposits of sand or rust will
clog up the water inflow filter.
1
B
2
B
A
The appliance must be connected to
the water mains using new hose-sets.
The old hose-sets should not be
reused.
The dishwasher can be connected to
either cold or hot water, as long as it
is no hotter than 60°C.
Bekijk gratis de handleiding van Iberna IDIN 1L38B-80, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Iberna |
| Model | IDIN 1L38B-80 |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 4480 MB |
