I-PRO WV-X67711-Z3L3 handleiding
Handleiding
Je bekijkt pagina 53 van 56
When this product is installed and operated in low temperatures below –20 °C {–4 °F}, it
may require time to start up since the camera will wait to be warmed up internally by the
internal heater right after the power is turned on.
Also, the camera may not function properly, if it is installed and operated in an environment
where the temperature is below –25 °C{–13 °F}. In such a case, wait approximately 2 hours
or more until the camera is warmed up. Then, turn on the power again.
As the camera warms up, snow or frost accumulated on the dome cover will melt. However, it
may not be defrosted from the cover depending on the ambient temperature or weather
condition.
When used at a low temperature, the moisture adhering to the wiper rubber may freeze and
become difficult to move.
・
Batteries
The battery is built into this product. Do not leave the battery in an environment exposed to
excessive heat from sunlight or fire.
・
Do not touch the front glass
If dirty, image quality may deteriorate.
・
When "WARMING UP-PLEASE WAIT" is displayed on the screen during use
The inside temperature of this product is low. Wait for the interior to warm up before this
product restarts automatically. Please wait for a while.
・
If this product is no longer in use, do not leave it unattended and must be removed.
・
Using the Wiper
Do not use the Wiper unless it is on rain/snow or when a Washer is used. When used in the dry
condition, the Wiper rubber will become worn. Note that the Wiper will automatically stop
running after 5 minutes.
・
Consumables
The following parts are consumables. Replace the watch with a new one based on the life time.
The lifetime varies depending on the operating environment and conditions. The life time is a
rough guide when used at +35 °C.
- Lens, PAN motor, TILT motor, Thin-wire coaxial cable for TILT, PAN main gear, TILT
main gear, gear unit: About 3.7 million cycles, Cooling fan: About 52,000 hours, Slip ring:
About 3.7 million cycles, Wiper rubber: About 0.12 million cycles (about 2 years), Wiper
motor: About 0.8 million cycles
* If the set position movement operation is continued for a long time, dust may accumulate
on the slip ring. Position refresh can be prevented by periodically (about once a week) by
setting a schedule.
For information about the slip ring of this product, refer to our technical information
6. Other
6.17 Precautions pertaining to usage
49
Bekijk gratis de handleiding van I-PRO WV-X67711-Z3L3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | I-PRO |
| Model | WV-X67711-Z3L3 |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 8407 MB |
