Handleiding
Je bekijkt pagina 24 van 40
EN - 24
II. DESCRIPTION OF THE APPLIANCE (FIG. 1)
A – propulsion unit
A1 – propulsion shaft
A2 – on/off switch
A3 – supply cord
B – bowl 600 ml
B1 – seal
B2 – plastic container base
B3 – knife
C – travel lid
C1 – lid plug
C2 – seal
III. PREPARATION FOR USE
Remove all packing material and take out the blender. Remove all possible adhesion
foils, stick-on labels or paper from the appliance. We recommend washing the container
before using it for the first time. The knife section is treated with oil not harmful to health for
technological reasons. Therefore first fill in the container with warm water (max. 50 °C) with
a small amount of detergent. Hold the knife (on the bottom) at the plastic base and slide
it (with the blade down) to the hole in the filled container, then turn it in the direction of the
maximum position. Then put the container on and run for 15 sec. Then rinse the container
and knife with clear water. Before the first use, wash the other parts that will be in contact
with food in hot water with a detergent, rinse thoroughly with clean water and wipe till dry,
or let dry the knife section is treated with oil not harmful to health for technological reasons.
Put the blender on a flat, stable, smooth and clean work surface at the height of at least
85 cm, out of reach of children and incapacitated people. Make sure that the power cord
is not damaged and that it does not lead through any sharp or hot surfaces. Plug power
supply fork to the electric power. Possible short-time mild smoke when the appliance is
operated for the first time is not a defect and the appliance is not subject to a complaint for
this reason.
Warning
When the blender is in the state of idle operation, e.g. the blade fails to touch the
foods, unplug the unit until the foods have been relaxed.
ACCESSORY INSTALLATIO
Bowl assembly and distribution (B), (pic. 2)
Put sealing B1 on the contact surface of the plastic base of container B2. Hold the knife
(on the bottom) at the plastic base and slide it (with the blade down) to the hole in the
filled container B, then turn it in the direction of the maximum position and tighten with
reasonable force. Remove the knife from the container in the opposite direction.
Attaching and removing the bowl (B), (pic. 3)
Mount the bowl B on drive A1 so that it slides down, then secure it by turning it clockwise
till you hear a snapping sound (at the same time, safety lock is unlocked). Pay special
attention to this operation. You can remove the bowl in the opposite direction.
Switch (A2), (pic. 5)
Start the drive by pushing the switch (the motor runs only for the time when the switch is
pushed). Push several times until you get the required result.
Bekijk gratis de handleiding van Hyundai PB 900, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hyundai |
| Model | PB 900 |
| Categorie | Blender |
| Taal | Nederlands |
| Grootte | 3463 MB |
