Hymer Exsis I (2025) handleiding
Handleiding
Je bekijkt pagina 196 van 240
12 Customer service and maintenance
196 Exsis I/T - 01/23-1 - EHG-0027-02EN
12.7 Changing windscreen blade
Only fill the cleaning agents (with/without frost protection) into the
washer fluid container which are listed in the operating manual of the
base vehicle manufacturer and in the mixing ratio specified therein. Do
not use any radiator frost protection or other products. These products
affect the cleaning effect and attack the windscreen blades.
It is recommended to change all two windscreen blades at once.
The windscreen blades are changed in the same way as on a car.
Fig. 157 Changing windscreen blade
◼ Remove the ignition key to prevent an involuntary activation of the wind-
screen wipers.
◼ Lift the wiper arm (Fig. 157,3) off the windscreen and fold out as far as it
will go.
◼ Push the synthetic clamping element on the windscreen blade
(Fig. 157,1) out of the bent holder on the wiper arm (arrow).
A small amount of resistance will be felt. If necessary, compress the syn-
thetic clamping element slightly.
◼ Install the new windscreen blade in the reverse order. Push the syn-
thetic clamping element into the bent holder of the wiper arm until it
locks into place.
◼ Clean the wiper nozzles (Fig. 157,2).
Bekijk gratis de handleiding van Hymer Exsis I (2025), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hymer |
| Model | Exsis I (2025) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 25423 MB |
