Hymer Exsis I (2025) handleiding
Handleiding
Je bekijkt pagina 164 van 240
10 Sanitary fittings
164 Exsis I/T - 01/23-1 - EHG-0027-02EN
10.2 Water pump
Fig. 137 Switch (water pump)
See table at end of section 10.7.
Before the water fittings can be used, the 12 V power supply and the wa-
ter pump must be switched on at the panel and on the switch (Fig. 137)
respectively. Otherwise the water pump will not work.
When the water tank is re-filled, an air bubble may form at the bottom of
the pump. This air bubble will prevent water from being drawn in. Shake
the water pump up and down energetically in the water.
10.3 Water system
10.3.1 Water tank
The water tank holds approx. 120 l.
Position of the water tank, see section 10.7.
Hot air from the living area heater heats the water tank. This protects the
water tank from frost.
If the living area heater is out of order, the water tank no longer is suffi-
ciently protected against frost. If there is a risk of frost, empty the water
tank and leave the drain cock open.
For driving safety and for regulatory reasons, when the vehicle is motion
the fill quantity must be reduced to approximately 20 litres. If the water is
drained using the safety drainage rotary handle (see section 10.3.4), a
residual quantity of approximately 20 litres will remain in the water tank.
Position
Bekijk gratis de handleiding van Hymer Exsis I (2025), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hymer |
| Model | Exsis I (2025) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 25423 MB |
