Hymer Exsis I (2025) handleiding
Handleiding
Je bekijkt pagina 105 van 240
Gas system 7
Exsis I/T - 01/23-1 - EHG-0027-02EN 105
7.8 Changing gas bottles
When changing gas bottles, do not smoke or create any open fire.
When you have changed the gas bottle, check whether gas escapes
at the connection points and unions. Use a leakage search spray to
spray the relevant connection point or union. These agents are availa-
ble at the accessories shop.
The procedure described below applies to vehicles that are equipped
with a single gas connection. If the vehicle is equipped with an regulating
system: When changing the gas bottle, proceed as described for the
regulating system.
Fig. 97 Gas bottle connection
◼ Open flap for the gas bottle compartment.
◼ Close the regulator tap (Fig. 97,4) on the gas bottle. Pay attention to the
direction of the arrow.
◼ Hold the gas pressure regulator (Fig. 97,2) and open the knurled nut
(Fig. 97,3) (normally a left-hand thread).
◼ Remove the gas pressure regulator and the gas tube (Fig. 97,1) from
the gas bottle.
◼ Release the fixing belts and remove the gas bottle.
◼ Place a filled gas bottle in the gas bottle compartment.
◼ Fix gas bottle in place with the fixing belts.
◼ Position the gas pressure regulator (Fig. 97,2) with gas tube (Fig. 97,1)
on the gas bottle and tighten the knurled nut (Fig. 97,3) (normally a left-
hand thread). Do not tighten too firmly.
◼ Close flap for the gas bottle compartment.
Bekijk gratis de handleiding van Hymer Exsis I (2025), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hymer |
| Model | Exsis I (2025) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 25423 MB |
