Hymer BMC-T (2023) handleiding
Handleiding
Je bekijkt pagina 68 van 286
5 Pitching the Motorcaravan
68 B-MC I/T - 01/23-1 - EHG-0016-03EN
◼ Switch on ignition.
◼ Apply the handbrake.
◼ Press the "Extend" (Fig. 47,5) button. The alignment procedure is per-
formed automatically. The "Steady leg" LEDs (Fig. 47,8) flash as long as
the steady legs are moving.
If the vehicle has folding supports: Movement of the steady legs ceases
after unfolding to give you the chance to put chocks in place. The "Auto-
matic mode" LED (Fig. 47,9) flashes rapidly.
◼ Press the "Extend" button (Fig. 47,5) again. The alignment procedure is
continued.
◼ Switch on ignition.
◼ Apply the handbrake.
◼ Press the brake pedal.
◼ Press the "Retract" button (Fig. 47,4). The steady legs retract comple-
tely. The "Steady leg" LEDs (Fig. 47,8) flash as long as the steady legs
are moving.
◼ Press the "On/Off/Mode" button (Fig. 47,6) briefly in Automatic mode.
The "Manual mode" LED (Fig. 47,1) lights up.
◼ Pay attention to the "Inclination" LEDs (Fig. 47,2). An illuminated LED
indicates that the vehicle must be raised on this side.
◼ Press the "Next" button (Fig. 47,7) as often as necessary until the desi-
red pair of steady legs is selected. The corresponding "Steady leg"
LEDs (Fig. 47,8) light up.
◼ Press the "Retract" (Fig. 47,4) or "Extend" button (Fig. 47,5) until the de-
sired position is reached.
◼ Press the "Next" button (Fig. 47,7) again until another desired pair of
steady legs is selected. Repeat the procedure until the vehicle is alig-
ned. The vehicle is aligned when the green "Position ok" LED (Fig. 47,3)
lights up.
◼ Ensure that all steady legs are in contact with the ground.
The OK position of the position sensor must be recalibrated following a
power failure (faulty fuse, battery disconnected).
◼ Align the vehicle in Manual mode using a spirit level.
◼ Press the "On/Off/Mode" (Fig. 47,6), "Extend" (Fig. 47,5) and "Retract"
(Fig. 47,4) buttons simultaneously and keep them pressed for 3 se-
conds.
◼ Release the buttons following audible acknowledgement and illumina-
tion of the "Position ok" LED (Fig. 47,3). The position is saved as the OK
position.
◼ Retract the supports in Automatic mode. This causes the controller to
readjust itself.
The vehicle can be lowered unexpectedly when the support valve is
opened. Do not go under the vehicle. Keep your hands away from the
crushing zone.
The steady legs can be retracted manually if there is an electrical failure.
Extending the steady legs
in Automatic mode:
Retracting the steady legs
in Automatic mode:
Manual mode:
Calibrating the position
sensor:
Emergency release
Bekijk gratis de handleiding van Hymer BMC-T (2023), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hymer |
| Model | BMC-T (2023) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 31425 MB |
