Hymer BMC-T (2023) handleiding
Handleiding
Je bekijkt pagina 19 van 286
Safety 2
B-MC I/T - 01/23-1 - EHG-0016-03EN 19
Use only 11 kg or 5 kg gas bottles. (The size of the gas bottles may
vary depending on the country.)
Use the shortest possible tube lengths (150 cm max.) for external gas
bottles.
Never block the floor ventilation openings below the gas bottles.
2.6 Electrical system
Only allow qualified personnel to work on the electrical system.
Prior to carrying out work on the electrical system, switch off all de-
vices and lights, disconnect the battery and disconnect the vehicle
from the mains.
Only use original fuses with the stipulated values.
Only replace defective fuses when the cause of the defect is known
and has been remedied.
Never bridge or repair fuses.
2.7 Water system
Water left standing in the water tank or in the water pipes becomes
undrinkable after a short period. Therefore, before each use of the ve-
hicle, thoroughly clean the water pipes and the water tank. After each
use of the vehicle completely empty the water tank and the water
pipes.
In the case of lay-ups lasting more than a week, disinfect the water
system before using the vehicle (see section 11.8.3).
If the vehicle is not used for several days or if it is not heated when there
is a risk of frost, empty the entire water system. Make sure that the 12 V
power supply on the panel is switched off. Otherwise, the water pump
will overheat and may get damaged. Leave the water taps on in central
position. Leave all drain cocks open. Frost damage to appliances, frost
damage to the vehicle and deposits in water-carrying components can
be avoided in this way.
Bekijk gratis de handleiding van Hymer BMC-T (2023), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hymer |
| Model | BMC-T (2023) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 31425 MB |
