Hymer BMC-T (2023) handleiding
Handleiding
Je bekijkt pagina 100 van 286
6 Living
100 B-MC I/T - 01/23-1 - EHG-0016-03EN
6.11.1 Satellite unit with automatic antenna alignment (Oyster)
Before commencing the journey, ensure that the antenna is in park
position. Danger of accidents!
When switching on the ignition, the antenna will automatically retract into
the idle position and lock there within a short period of time. However,
before setting off, the driver must verify the correct position of the an-
tenna.
Retract the satellite antenna in case of strong wind or storm.
Do not wash a vehicle with a satellite antenna in a brush washing sys-
tem, nor in a vehicle washing installation, nor with high-pressure clean-
ers.
The vehicle must be still during the satellite search. Do not walk through
the vehicle.
Pay attention to a "free visibility towards the south". From the European
point of view, all the satellites are located approximately to the south.
Satellite reception is only possible, when the antenna is positioned in di-
rect line of sight of the chosen satellite and the view is not blocked in any
way.
The satellite unit can be adjusted with the control unit. Refer to the man-
ufacturer's instruction manual about this.
If the location is adjusted with the help of the list of countries, the satel-
lite search will be accelerated.
The satellite antenna will automatically be aligned with a pre adjusted satel-
lite if the receiver system is within the reach of this satellite. The operation of
the satellite unit is not possible while the ignition is switched on.
1 Lighted display
2 OK Button
3 Next/Back buttons
4 On/Off button
Fig. 98 Control unit (satellite unit)
The control unit is installed in a wall-mounted cupboard above the seating
group.
The lighted display shows information regarding the current operating status
of the satellite unit. To protect the battery, the lighting goes out after a while.
◼ Switch the receiver on. The satellite antenna raises automatically after
starting up the receiver (up to 90 seconds).
◼ Alternatively: Press On/Off button on the control unit.
Position of the control
unit
Switching on, erecting and
aligning:
Bekijk gratis de handleiding van Hymer BMC-T (2023), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hymer |
| Model | BMC-T (2023) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 31425 MB |
