Husqvarna-Viking Huskystar 215 handleiding
Handleiding
Je bekijkt pagina 25 van 40
23
Tape the button over the placement mark. A
pin can be taped on top of the foot to form a
shank.
- Set the pattern selector at " 2 " for Model 207.
- Set the pattern selector at " 0 " for Model 215.
Align both holes of the button with the slot of
the foot and place the left hole of the button
just below the needle point.
Lower the foot.
- Turn the Pattern Selector Dial for Model 207,
- Turn the Stitch Width Dial for Model 215,
until the needle point comes just above the
right hole of the button.
Sew about fi ve stitches and raise the needle.
To strengthen the shank, cut the threads leaving
a 20 cm (8') tail. Bring the needle thread down
through the hole in the button and wind it
around the shank. Draw the thread to the
wrong side and knot.
Note: When sewing the button is complete, raise the feed
teeth.
1
2
3
4
5
0
Stitch selector: 3 Stitch length: Set at any number (no fi xed setting)
Stitch width: Adjust the stitch width to match the holes on the button. (Model 215 only)
Presser foot: Zigzag foot Thread tension:4 - 6 Feed teeth: Dropped (See page 16.)
Sewing Buttons
1/2
3
4
5
6
7
8
1
4
2
3
0
1
2
3
4
8
1
1
2
3
4
5
6
1
2
3
4
5
6
Bekijk gratis de handleiding van Husqvarna-Viking Huskystar 215, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Husqvarna-Viking |
| Model | Huskystar 215 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 5178 MB |
