Husqvarna-Viking Designer Topaz 25 Handleiding (88 Pagina's)

Handleiding

21SET UP

LOWER THE FEED TEETH

The feed teeth are lowered when you move the switch on the

front of the free arm to the right. Move the switch to the left

if you wish to raise the feed teeth. The feed teeth will raise

as you begin to sew. The feed teeth should be lowered when

sewing on buttons and for free motion sewing.

CHANGING THE PRESSER FOOT

Press the ON/OFF switch to “O”.

1. Make sure the needle is in the highest position and the

presser foot is lifted. Pull the presser foot towards you.

2. Line up the cross pin on the foot with the gap in the

presser foot ankle. Push back until the foot snaps into

place.

CHANGING THE NEEDLE

Press the ON/OFF switch to “O”.

1. Loosen the screw in the needle clamp with the screwdriver.

2. Remove the needle.

 3XVKWKHQHZQHHGOHXSZDUGVZLWKWKHÁDWVLGHDZD\IURP

you until it will go no further.

4. Use the screwdriver to tighten the screw properly.

Bekijk gratis de handleiding van Husqvarna-Viking Designer Topaz 25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.