Husqvarna-Viking Designer Ruby Royale Handleiding (134 Pagina's)

Handleiding

2:5Set up

B

A

C

A

B

THREADING FOR TWIN NEEDLE

Replace the sewing needle with a twin needle. Make

sure the presser foot is raised and the needle is in the up

position.

1. Lift the spool pin up and all the way to the right.

Lock the spool pin in the vertical position by slightly

pressing it down. Slide on the large spool cap. For

spools smaller than the medium size spool cap, place a

felt pad under the thread spool.

2. Place the rst thread spool on the spool pin. The

spool should rotate in a clockwise direction when the

thread reels off the spool.

3.

LEFT NEEDLE: Thread the machine as described on page

2:4. Check to ensure that the thread lies between the

left thread tension discs (A). Thread the left needle

manually.

4. Pull out the auxiliary spool pin and slide on the large

spool cap. For spools smaller than the medium size

spool cap, place a felt pad under the thread spool.

5. Place the second thread on the spool pin. The second

spool should rotate in a counterclockwise direction

when the thread reels off the spool.

6.

RIGHT NEEDLE: Thread the machine as before but this

thread should lie between the right thread tension discs

(A) and outside the needle thread guide (B). Thread

the right needle manually.

Note: Activate and choose the correct needle width in Sewing Settings

in SET Menu to prevent damage on the needle or the presser foot.

Note: The weight and irregular surface of specialty threads such as

metallic increases the amount of friction on the thread. By reducing

the tension, the risk of needle breakage and thread breakage is

reduced.

THREAD CUTTER

There are three thread cutters on your machine. The rst

one is close to the bobbin winder spindle (A) for cutting

the thread before and after winding. The second one is

next to the bobbin area (B) for cutting the bobbin thread

after placing it in the machine. The third one is on left side

of the machine (C) for manually cutting top and bobbin

threads. Pull both threads into the cutter from the back to

the front and pull down quickly.

Bekijk gratis de handleiding van Husqvarna-Viking Designer Ruby Royale, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.