Hughes & Kettner TubeMeister 36 handleiding

Niet gecategoriseerd

Hughes & Kettner

80 pagina's

PDF beschikbaar

Handleiding

Press and hold the two ON buttons for FX LOOP

and REVERB simultaneously for more than three

seconds to save the settings and quit MIDI setup

mode. The buttons will stop flashing to indicate the

amp is back in normal operating mode.

3.3 Factory Settings and How to

Restore Them (Factory Reset)

To reset the amp to the factory default settings,

press and hold the REVERB ON and FX LOOP

ON while powering up simultaneously until the

MIDI LEARN button lights up. After you release

the ON buttons, MIDI LEARN will flash once

to confirm that the reset has been executed properly.

The factory defaults are:

• OMNI ON

• MIDI Channel 1

The factory default settings and assignments for

sounds are:

MIDI

Program

Preamp

Channel

Power

Output

Loop REVERB

1Clean36 WOFFON

2 Crunch 36 W OFF OFF

3 Lead 36 W OFF OFF

4Clean0 WOFFOFF

5Clean18 WOFFON

6 Crunch 18 W OFF OFF

7 Lead 18 W OFF OFF

8Clean0 WOFFOFF

9Clean5 WOFFON

10 Crunch 5 W OFF OFF

11 Lead 5 W OFF OFF

12 Clean 0 W OFF OFF

13 Clean 1 W OFF ON

14 Crunch 1 W OFF OFF

15 Lead 1 W OFF OFF

16 Clean 0 W OFF OFF

4 Tube Safety Control (TSC™)

TSC™ adjusts bias to improve the amp’s tonal and

technical stability and extend power tubes’ life. It

does this automatically and continuously, so there is

nothing for you to do but enjoy the convenience.

Swapping tubes is more easily, quickly, and safely

done than with a conventional amp. This is a big

help not only in case of a defect, but also when you

want to compare different brands of replacement

tubes.

CAUTION: Replacing tubes is a job for qualified

professionals! TSC™ merely spares the technician the

biasing effort.

What do the LEDs indicate?

Each LED is assigned to the power tube occupying

that same position. Getting a read-out of tubes’

operating status and bias points is easy using any

standard guitar pick.

4.1 Automatic Status Indications:

All LEDs Light Up And Stay On

All LEDs remain on for as long as the amp is in

standby mode. When you flip the STANDBY

switch to PLAY, they will extinguish after about 30

seconds. If the LEDs remain illuminated, the most

likely cause is a blown anode fuse that needs to be

replaced by a technician. The anode fuse can trip if

a tube is already defective when the amp is switched

on, and TSC does not have enough time to measure

idle current and shut the faulty tube down.

None of the LEDs Lights Up

The power tubes are operating normally.

One LED Lights Up Continuously

The tube assigned to this LED is not delivering

enough current and has been shut down. If the LED

does not extinguish after a few minutes, this tube

must be replaced.

Bekijk gratis de handleiding van Hughes & Kettner TubeMeister 36, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.