Hughes & Kettner TriAmp MKII handleiding
Handleiding
Je bekijkt pagina 8 van 32
REAR
MAINS IN: Socket for the included Euromains
power cable. Before plugging into the wall socket,
make certain the amp's voltage rating as dis-
played in the VOLTAGE SELECTOR window
matches your local AC voltage rating.
VOLTAGE SELECTOR: If you need to change
TriAmp
®
MK II's voltage to your local AC voltage
rating, pull out this cartridge and see Section 2.1
for further details.
ANODE FUSE: Fuse holder for the power amp's
anode fuses. Be sure you only use fuses rated to
the indicated specifications.
HALF POWER: This power soak switch cuts the
TriAmp
®
MK II’s output power in half from
100 watts to 50 watts.
PREAMP OUT, POWER AMP IN: The TriAmp
®
MK II
sports an ancillary serial FX loop that lets you
control master volume via a volume pedal.
The preamp signal is patched out via PREAMP OUT
jack and in again via POWER AMP In.
STAGEBOARD: Input jack for TriAmp
®
MK II
STAGEBOARD. The length of the cord can be
extended using standard computer cables
(equipped with 9-pin SUB-D connector).
FX LOOP
FX SERIAL/PARALLEL: An innovative new feature
of the TriAmp
®
MK II, it lets you select the desired
type of effects loop, parallel or serial, at the touch
of a button. The FX loop setting may be stored
and switched via MIDI using the optional
MSM-1 MIDI module.
LEVEL: Determines the relative levels of the
TriAmp
®
MK II’s preamp signal and the signal
routed into the FX RETURN jack as sent from a
connected effects device and the like. In other
words, use it to set the desired wet/dry mix.
FX SEND: Connect this jack to your effects
processor's input jack.
FX SEND LEVEL: This damping switch allows you
to adapt the signal level to lower-level effects
devices. Press this switch in for instrument level
processors (e.g. stomp boxes).
FX RETURN: Connect this jack to your effects
processor's output jack.
RED BOX
®
DI OUT: This is a balanced output
featuring the RED BOX
®
Cabinet Simulator.
It enables you to feed the TriAmp
®
MK II signal
directly to a mixing console for stage and
recording purposes. Refer to Section 4.3 for details.
SPEAKER: The TriAmp
®
MK II features 4-, 8- and
16-ohm speaker outs for perfect impedance
matching. Its minimum impedance is 4 ohms.
NOTE:
Never operate the TriAmp
®
MK II without
a loudspeaker connected!
TRIAMP MK II - MANUAL
8
8
Bekijk gratis de handleiding van Hughes & Kettner TriAmp MKII, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hughes & Kettner |
| Model | TriAmp MKII |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11034 MB |
