Hughes & Kettner Switchblade Head 100 handleiding
Handleiding
Je bekijkt pagina 23 van 68
Switchblade
23
english
Switchblade is connected
properly, but no sound is audible.
• The guitar’s VOLUME knob is turned all the way down.
• The amp is set to STANDBY.
• The amp’s VOLUME knob is turned all the way down.
• The effects loop is active and set to SERIAL, but no effect device is
connected.
• The anode fuse has blown. Ensure that it is replaced with a fuse of
the same rating.
• The fuse for the tube heating tripped (the tubes don’t glow). Ensure
that it is replaced with a fuse bearing the same rating.
The amp makes ringing noises
when played and tends to Feedback.
• One or several tubes are microphonic. Replace the defective tube
with another of the same type.
Signs of tube wear such as increased microphonics and
noise, Treble loss, weak power output or muddy sound
begin reappearing just a few hours after replacing tubes.
• The wrong tubes were installed when old tubes were replaced or
the amp was not biased properly. Take the amp to a professional to
correct the problem.
The sound is washed out or muddy when you switch an
effects processor on.
• The signal processor provides a wet signal that is blended with
the dry or original signal. Depending on the type of effect, the
processor may be returning a dry signal back along with wet signal,
which causes phase cancellations when mixed to the dry signal in
Switchblade’s Parallel loop. To prevent this, set the effects loop
to SERIAL or turn the dry signal all the way down on the signal
processor.
COMBO 50
Bekijk gratis de handleiding van Hughes & Kettner Switchblade Head 100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hughes & Kettner |
| Model | Switchblade Head 100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 20471 MB |
