Hughes & Kettner Edition Tube 25th Anniversary handleiding

Niet gecategoriseerd

Hughes & Kettner

32 pagina's

PDF beschikbaar

Handleiding

• Be sure the AC power source delivers the current

that your amp is designed to handle before you

plug it in. When in doubt about the local rating,

ask the venue’s sound technician or a stage hand.

• Refrain from DIY repairs! To be on the safe side,

you should also have a qualified technician replace

internal fuses.

5.0 Troubleshooting

The Edition Tube is not getting any power:

• Check the mains cable to see if it is connected

properly.

• The mains fuse may be defective. Replace the fuse

with another identical fuse. If this fuse also trips,

consult your Hughes & Kettner dealer.

The Edition Tube is connected properly, but no

sound is audible:

• One or several GAIN and MASTER controls

may be turned all the way down. Dial in a higher

setting.

• A short circuit in the speaker signal chain may have

tripped an internal fuse, or one of the power tubes

is defective. Replace the speaker cable and have a

qualified service technician replace the fuse/tube

(identical specifications are a must). Please read

Section 4.0 on how to replace tubes correctly.

The sound is slightly distorted and you cannot get

a truly clean tone:

• The input section is being overdriven. Depending

on the type of pickups in your guitar, this effect

is very pronounced or may not be audible at all.

If you don't want this slight distortion (although

many players prefer a little dirt in their sound),

reduce the volume of your guitar or volume pedal,

turn the screws on the frame of your pickups so the

distance between the strings and pickups is greater,

or try a different combination of pickups.

• If the distortion has an annoying gritty edge to it,

there may be some type of fault due to improper

use of a signal circuit, for instance a speaker output

connected to the Edition Tube's input. In this case,

consult your Hughes & Kettner dealer.

You have connected an FX processor to the SEND

jack and the signal is totally distorted, even when

you have dialed in a clean sound:

• The LINE OUT signal is overloading the input

of the FX processor. Reduce the processor‘s input

sensitivity ("INPUT" or "GAIN").

You have connected an FX processor to the SEND

jack of the Edition Tube and the signal's volume

level is way too low:

• The FX processor's output level is set incorrectly.

Turn it up.

6.0 Technical Specification

Input: -20 dBV/1 MOhm

FX-Return: 0 dBV/47 kOhms

FX-Send: 6 dBV/ 100 Ohms

Power amp section: EL84 tube amp

Output Power: 20 W RMS (into 8 Ohms)

Lautsprecher: Celestion® G12T-100,

8 Ohm

Voltage: 220-230 V

120 V

100 V

Max. power-consumption: 100 W

Mains Fuse: T500 mA

(220-230 V modell)

T1A (120 V modell)

T1A (100 V modell

Anode Fuse: T200 mA

Secondary Fuses: T160 mA (low voltage)

Ambient temperature

range in operation: 0°C to +35°C

Dimensions (WxHxD): 556 x 480 x 276 mm

Weight: 18,4 kg (approx.)

english

Bekijk gratis de handleiding van Hughes & Kettner Edition Tube 25th Anniversary, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.