Handleiding
Je bekijkt pagina 25 van 52
EN / 25
• The electric cable must not be crushed,
folded, jammed or touch hot parts of the
product. If the electric cable is damaged,
it must be replaced by a qualified electri-
cian. Otherwise there is an electric shock,
short circuit or fire hazard!
• The mains supply data must correspond
to the data specified on the type label of
the product. The rating plate is either
seen when the door or the lower cover of
the appliance is opened or it is located at
the rear wall of the appliance depending
on the appliance type.
• and must use the appropriate socket out-
let/line and plug for oven. In case of the
product's power limits are out of current
carrying capability of plug and socket
outlet/line, the product must be connec-
ted through fixed electrical installation
directly without using plug and socket
outlet/line.
If your appliance has a cord and plug:
Perform the electrical connection of your
appliance by plugging it to a grounded
socket.
The moulded plug on this appliance incor-
porates a 3 A fuse. Should the fuse need to
be replaced an ASTA approved BS1362
fuse of the same rating must be used. Do
not forget to refit the fuse cover. In the
event of losing the fuse cover, the plug
must not be used until a replacement fuse
cover has been fitted. Colour of the replace-
ment fuse cover must be the same colour
as that visible on the pin face of the plug.
Fuse covers are available from any good
electrical store.
Fitting a different plug
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals on your plug, proceed as follows:
• Brown cable = L (Live)
• Blue cable = N (Neutral)
• Green/yellow cable must be connected to
ground (E) line.
With the alternative plugs a 3 A fuse must
be fitted either in the plug or adaptor or in
the main fuse box. If in doubt contact a
qualified electrician.
4.3 Gas connection
• There is risk of explosion, fire and toxica-
tion could be occur if installation, repair
or connection are made from unauthor-
ised/unlicensed/ unqualified person or
technician.
• Before placing the product, make sure
that the local distribution conditions (gas
type and pressure) and whether the
product gas setting complies with these
conditions. Gas adjustment conditions
and values of the product are located on
the labels (or type label).
• If your country code is not on the label,
follow the local technical instructions for
your country for gas connection and con-
version.
• Product can be connected to gas supply
system only by an authorised/licensed/
qualified person or technician.
• Manufacturer shall not be held respons-
ible for damages arising from procedures
carried out by unauthorised/unlicensed/
unqualified person or technician.
• Before starting any work on the gas in-
stallation, disconnect the gas supply.
There is the risk of explosion!
Bekijk gratis de handleiding van Hotpoint HTG6GDCW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hotpoint |
| Model | HTG6GDCW |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5698 MB |
