Handleiding
Je bekijkt pagina 11 van 78
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues. To
dry any condensation that has formed as a result of
cooking foods with a high water content, leave the
oven to cool completely and then wipe it with a cloth
or sponge.
• Activate the “Diamond Clean” function for optimum
cleaning of the internal surfaces. (Only in some
models).
• Clean the glass in the door with a suitable liquid
detergent.
• The oven door can be removed to facilitate cleaning.
• Dry out the bottom profile below the door of the
oven if water residues are present after a cooking
cycle.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
Do not clean Food Probe and Meat Probe (if present)
in the dishwasher.
Air Fry tray (if present) can be cleaned in the dishwasher.
Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance
work.
MAINTENANCE AND CLEANING
CLEANING THE CATALYTIC PANELS
ONLY IN SOME MODELS
This oven is equipped with special catalytic panels
that facilitate cleaning of the cooking compartment
thanks to their special self-cleaning coating, which is
highly porous and able to absorb grease and grime.
These panels are fitted to the shelf guides: When
repositioning and then refitting the shelf guides,
make sure that the hooks at the top are slotted into
the appropriate holes in the panels.
To make best use of the catalytic panels’ self-cleaning
properties, we recommend heating the oven to
200 °C for around one hour using the “Convection
Bake” function. The oven must be empty during
this time. Then leave the appliance to cool down
before removing any remaining food residues using a
nonabrasive sponge.
Please note: Using corrosive or abrasive cleaning agents,
stiff brushes, pan scourers or oven sprays could damage
the catalytic surface and compromise its self-cleaning
properties.
Please contact our After-sales Service if you require
replacement panels.
REPLACING THE LAMP
1. Disconnect the oven from the power supply.
2. Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
3. Reconnect the oven to the power supply.
Please note: 40 W/230 ~ V type G9, T300°C halogen
bulbs.
The bulb used in the product is specifically designed for
domestic appliances and is not suitable for general room
lighting within the home. (EC Regulation 244/2009) Light
bulbs are available from our After-sales Service.
If using halogen bulbs, do not handle them with your
bare hands as your fingerprints could cause damage. Do
not use the oven until the light cover has been refitted.
Bekijk gratis de handleiding van Hotpoint HAOI5S8HM0XA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hotpoint |
| Model | HAOI5S8HM0XA |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 11452 MB |
