Hotone Eko handleiding
Handleiding
Je bekijkt pagina 4 van 21
DESIGN INSPIRAT I O N
1. ON/OFF: For switching this unit on/off. The LEDs under the upper 5 knobs indicate
effect on/off status.
2. PATCH/TAP: Tap for selecting forward patches in current bank, hold for
engaging/disengaging tap tempo mode.
3. +/- buttons: For selecting effects and adjusting parameters.
4. GLOBAL: For setting expression pedal, input mode, and other parameters.
5. SAVE/EXIT button: For saving or canceling parameter changes.
6. OLED screen: Shows bank/patch numbers, setting values and other operation info.
7. MIX: Controls effect wet/dry signal ratio (varies with effects).
8-9. A/B: Control detailed effect character (varies with effects).
10. F.BACK: Controls the delay feedback amount (varies with effects).
11. TIME: Controls the delay time. In Tap Tempo mode, use TIME knob to set a Tap Tempo
subdivision*, and the TIME LED will keep flashing.
12. INPUT: 1/4” (6.35mm) stereo jack, for plugging in instruments or other effects. A Y
cable is needed when connecting to stereo pedal outputs.
13. EXP: 1/4” (6.35mm) TRS jack, for connecting expression pedals. The expression pedal
should have a TRS cable attached to it. We recommend using a Hotone Soul Press
(switched to EXP mode) for expression control.
14-15. OUTPUT (L & R): 1/4” (6.35mm) mono jacks, for connecting to amps or other effects.
16. USB jack: Mini USB jack, for effects editing, firmware updates, and factory reset.
17. DC 9V: Plug in your power supply here (DC 9V, center negative).
Panel Introduction
*Requires firmware v1.1.1 or later
Bekijk gratis de handleiding van Hotone Eko, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hotone |
| Model | Eko |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1935 MB |
