Hoshizaki Steelheart PR93B-D6 handleiding

Koelkast

Hoshizaki

49 pagina's

PDF beschikbaar

Handleiding

2. Startup:

5) Plug the appliance into the electrical outlet. WARNING! To reduce the risk of electric

shock, do not touch the plug with damp hands. At startup, there is a slight delay

before the compressor starts.

6) Conrm the cabinet control setpoint is 35°F (1.7°C) on

the cabinet control module located on the front panel. See

Fig. 41. To conrm the setpoint, press the up arrow key

for 2 seconds and release. The setpoint ashes. If not set

to 35°F (1.7°C), see "II.C.2 Cabinet Temperature Control"

below. NOTICE! Cabinet temperature control does not

control compressor operation. Only cabinet fan motor

operation. For compressor operation control see "II.C.

Rail Control Dial Adjustment."

7) Allow the appliance to cool down prior to loading it with food

products. Conrm all rail dividers and pans are in place.

B. Pre-Startup and Startup

WARNING

All parts are factory-adjusted. Improper adjustments may adversely affect safety,

performance, component life, and warranty coverage.

1. Pre-Startup:

1) Wash the pans and cutting board before use.

2) Conrm all pans and rail dividers are in place. Do not leave any gap between pans or

appliance. Close the rail cover(s). NOTICE! The entire rail must be covered by rail

dividers and pans (up to 6"(15cm)deep)) and the rail cover must be closed at

startup. Otherwise, the appliance will not cool down properly. See "I.C.6. Pans

and Rail Dividers" for details. Leave the pans empty until the appliance cools down.

WARNING! When the rail cover is open, make sure the rear pins on both sides of

the rail cover are securely in the rear slots and the front pins are resting securely

in the notches. Otherwise, the rail cover could close suddenly and cause injury.

3) If not already installed, install the cutting board. See "I.C.7. Attach the Cutting Board" for

details. WARNING! Make sure the cutting board brackets and cutting board are

secure. Otherwise, the cutting board could come off and cause injury.

4) Locate the rail control dial inside the cabinet and conrm the rail control dial is set to 5.

See Fig. 40. The rail control dial is located on the left side wall of the cabinet interior.

Factory Default: 5 (27°F (-2.8°C)).

Cabinet Control Module

Fig. 40

Fig. 41

Left Side Wall of

Cabinet Interior

Rail Control Dial

12 o'clock Setpoint Position

Setpoint Position 5

Rail Control Dial

Bekijk gratis de handleiding van Hoshizaki Steelheart PR93B-D6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.