Handleiding
Je bekijkt pagina 12 van 30
12
temperature is not in proper range check the CTh status. See "II.D. Thermistor
check”, If CTh ohm reading is in proper range replace controller.
If the compressor icon appears in the display and the set point and the temperature
in the display is correct, check If 115VAC is present at the controller terminals #5
(Black Smooth) and #7 (White) If 115VAC is not present, check if 115VAC is present
at controller terminals #4 (Black Striped) and #7 (White), if it is present replace the
controller.
If the CondFM is energized but Comp is not, check for 115VAC at Comp thermal
protector and neutral (White) in the compressor. If 115VAC is not present, give time
for Comp thermal protector to cool and reset. If Comp protector does not reset,
replace Comp thermal protector. If 115VAC is present, check Comp start capacitor,
start relay, and Comp motor windings. If CondFM is not energized, check CondFM
fan blades for binding and motor winding continuity.
If Comp and CondFM are energized and the cabinet does not cool down, check for
a restriction in the refrigeration circuit, check the suction pressure, and correct
refrigerant charge, see "VIII. Technical information".
8) Cool Down Achieved-CTh cools to Setpoint of 32°F (0°C). EvapFM continue on, Comp
and CondFM de-energize. Diagnosis: Confirm Comp and CondFM de-energize. If not, and
Comp and CondFM were energized longer than 3-min. check if the Comp icon in the display
is off, if the Comp icon is present, check the set point. Check the CTh status. See "II.D.
Thermistor Check" If CTh ohm reading is in range and Comp and CondFM continue longer
than 3-min., check for 115VAC at the controller terminals #5 (Black Smooth) and #7 (White) If
115VAC is present replace the controller.
9) Defrost. There is a 25-min. defrost time each 6-hr. after power on or energy restore.
1b) Manual Initiation: To initiate a manual defrost, press and hold the snowflake
button for 5 seconds. The snowflake icon appears in the display. EvapFM
continue energize Comp and CondFM de-energize. The last temperature on
display is holding during the defrost time (the temperature do not change on the
display during defrost time).
2b) Manual Termination Defrost: P
ress and hold the snowflake button for
5 seconds, the snowflake icon in the display must turn off, and the compressor
icon must be blinking in the display, 3-min. Comp delay timer starts, after the
delay timers terminate the Comp and CondFM energize.
C. Controller Check
1. Controller
Bekijk gratis de handleiding van Hoshizaki CC50-S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hoshizaki |
| Model | CC50-S |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 3862 MB |
