Hoover HE106HM 011 handleiding
Handleiding
Je bekijkt pagina 4 van 56
2
L. Suction Control Slider
M. Carpet and Floor Nozzle**
N. Main Cleaner
O. Bag Door Release Latch
P. Bag Holder
Q. Pre-motor Filter Frame
R. Pre-motor Filter
S. Exhaust Filter
T. Pet Hair Remover Mini Turbo Nozzle*
U. Allergy Remover Mini Turbo Nozzle*
V. Parquet Nozzle*
* Certain Models Only ** Certain models only, nozzles may vary according to model
GETTING TO KNOW YOUR CLEANER
GB
A. On/Off Button
B. Bag Door
C. Telescopic Tube Adjuster
D. Telescopic Tube
E. Suction Regulator
F. Hose Handle
G. Hose
H. Bag Check Indicator
I. Cord Rewind Button
J. Exhaust Filter Cover
K. 2 in 1 Tool
ASSEMBLING YOUR CLEANER
Remove all components from the packaging.
1. Connect the hose to the cleaner main body, ensuring it clips and locks into position. [1]
To release: simply press the two buttons on the hose end and pull. [1]
2. Connect the tube upper end to the handle. [2]
3. Connect the tube lower end to the carpet and oor nozzle**. [3]
USING YOUR CLEANER
1. Extract power cord and plug it into the power supply. Do not pull the cord beyond the
red marker. [4]
2. Adjust the length of telescopic tube by moving the telescopic tube adjuster up, and raise
or lower the handle to the most comfortable cleaning position. [5]
3. A
fter
connecting the telescopic tube to the Carpet and Floor Nozzle, adjust the suction
control slider on the nozzle according to your cleaning needs [6]:
Hard Floor Cleaning: Adjust the suction control slider on the nozzle to the symbol. [6]
Standard Carpet: Adjust the suction control slider on the nozzle to the symbol. [6]
Long Pile Carpet: Adjust the suction control slider on the nozzle to the symbol.
[6]
To obtain the best performance and efciency on Carpet adjust the suction control
slider on the nozzle to the symbol. [
]
The suction control can also be used to reduce the operating push force.
4. Switch the cleaner on by pressing the on/off button on the cleaner main body. [7]
5. Adjust the suction regulator to the desired level. [8]
6. Switch off at the end of use by pressing the on/off button. Unplug and press the cord
rewind button to wind the power cord back into the cleaner. [9]
7. Packing and storage – The tube can be parked for temporary storage while in use, or
in the storage position when not in use. [10]
CLEANER MAINTENANCE
Replacing the Dust Bag
If the bag check indicator is red please check and, if necessary, replace the bag.
1. Lift the bag door release latch [11] to open the bag door. Pull the bag holder [12] and
pull the bag collar to remove the bag. [13]
2. Apply the peel and seal sticker, located on the bag collar, to the bag inlet. The full dust
bag should be disposed of correctly and carefully.
3. Fold a new bag as shown on the bag and t by inserting the collar into the bag holder. [13]
4. Ret the bag holder and close the bag door.
WARNING: The bag door will NOT close if the dust bag and/or the bag holder are not
assembled to the cleaner. Always ensure the bag and bag holder are present when
closing the bag door.
REMEMBER: The bag check indicator may also be red if an obstruction has occurred. In
this case, refer to ‘Removing a blockage from the system’.
Cleaning the Filters
To maintain optimum performance of your cleaner, please wash the lters after each 5
bag changes.
Cleaning the pre-motor lter:
1. Lift the bag door release latch [11] to open the bag door and remove the bag. [12]
2. To remove the pre-motor lter, slide the pre-motor lter frame from the cleaner. [14]
3. Remove the lter from the holder. [15]
4. Wash it in hand warm water [18], and allow it to dry thoroughly before replacing it in
the cleaner. [19]
Cleaning the exhaust lter:
1. To remove the exhaust lter, unclip the exhaust lter cover [16] and remove the exhaust
lter pack. [17]
2. Wash the lter in hand warm water [18] and allow it to dry thoroughly before replacing
it in the cleaner. [19]
REMEMBER: Do not use hot water or detergents. In the unlikely event of the lters
becoming damaged, t a genuine Hoover replacement. Do not try and use the product
without a dust bag or lter tted.
Cleaning the permanent cloth dust bag*:
To maintain optimum performance we recommend that you wash the permanent cloth
dust bag under hand warm water after every 5 full bags. Remove excess water and leave
to dry fully before replacing.
Bekijk gratis de handleiding van Hoover HE106HM 011, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hoover |
| Model | HE106HM 011 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 7518 MB |
