Hoover HBR 49SBL8G-80 handleiding
Handleiding
Je bekijkt pagina 9 van 40
9
2-Installation
EN
Following connections are possible:
2.6.1 Drain hose to sink
f
Hang the drain hose with the U-support over
the edge of a sink with adequate size (Fig. 2-5).
f
3URWHFWWKH8VXSSRUWVXƬFLHQWO\DJDLQVWVOLS
ping.
2.6.2 Drain hose to waste water connection
f
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
f
Put the drain hose for 80-100 mm in the wast-
ewater pipe.
f
Attach the U-support and secure it suƬFientl\
(Fig. 2-6).
2.6.3 Drain hose to sink connection
f
The Junction must lie above the siphon.
f
A spigot connection is usualO\ closed E\ a pad
(A). That must be removed to prevent an\
disfunction (Fig. 2-7) .
f
Secure the drain hose with a clamp.
CAUTION!
f
The drain hose should not be submerged in water and should be secureO\ ƪ[HG and
leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less
than 80 cm, the washing machine will contiQXRXVO\ drain while being ƪlled (self-
siphoning).
f
Drain hose is not to be e[Wended. If necessar\ contact after sales service.
2.7 Drain hose to sink connection
Make sure that the gaskets are inserted.
1. Connect the water inlet hose with the angled end
to the appliance (Fig.2-8 ).Tighten the screw
2. The other end connects to a water tap with a 3/4
thread (Fig.2-9).
2-8 2-9
-RLQWE\KDQG
2-5
2-6
2-7
Bekijk gratis de handleiding van Hoover HBR 49SBL8G-80, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hoover |
| Model | HBR 49SBL8G-80 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 5297 MB |
