Honeywell X1N handleiding
Handleiding
Je bekijkt pagina 15 van 56
15
Troubleshooting
Display is blank • Make sure fresh AA alkaline batteries are correctly installed (see Step 7
of the section Installing the Thermostat)
Heating or cooling
does not run
• When running heat, display will show HEAT ON in lower right of display
• When running cool, display will show COOL ON in lower right of display
• If display shows WAITING FOR EQUIPMENT under temperature
reading, it is in compressor delay mode to protect the system. Wait 5
minutes to see if the thermostat makes a Heat or Cool call
• If display does not indicate a call for Heat or Cool or WAITING FOR
EQUIPMENT, verify the mode setting, temperature setpoint and room
temperature
If the Up or Down arrow is pressed
• Upper left of display shows mode setting
• Upper right shows setpoint
• Center of display shows room temperature
If the issue persists
• Check circuit breaker and reset if necessary
• Make sure power switch at heating & cooling system is on
• Make sure furnace door is closed securely
Heat runs with
Cooling
• Verify there is not a wire attached to W for heat pump systems. See
Wiring section
• For heat pump applications the reversing valve is energized in Heat on
some heat pumps and Cool for other heat pumps. Verify that ISU 2060
is set correctly
• Verify that no wires are shorted. Look for exposed sections of wire at the
UWP
Heat runs with
no call for heat or
cooling
• Verify display does not indicate HEAT ON or COOL ON
• Verify there is not a wire attached to W for heat pump systems. See
Wiring section.
• Verify that no wires are shorted. Look for exposed sections of wire at the
UWP
Cannot change
setpoint to desired
setting
• Verify the mode setting (Heat, Cool or Auto in upper left of display)
The setting ranges for these modes are:
• Heat: 32 ºF to 90 ºF (0 ºC to 32.0 ºC)
• Cool: 50 ºF to 99 ºF (10.0 ºC to 37.0 ºC)
WAITING FOR
EQUIPMENT
shown in display
under room
temperature
• The compressor protection feature is engaged. Wait a few minutes for
the system to safely restart to avoid damaging the compressor.
Bekijk gratis de handleiding van Honeywell X1N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Honeywell |
| Model | X1N |
| Categorie | Thermostaat |
| Taal | Nederlands |
| Grootte | 4884 MB |
