Holzmann ED750FDQ handleiding
Handleiding
Je bekijkt pagina 58 van 95
OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 58
ED750FDQ
18.9.5 Plain turning and recessing
When facing, the turning tool is moved at right angles to
the axis of rotation. The feed is done manually with the
handwheel of the facing slide. The feed of the cutting depth
is effected by the top slide or the bed slide.
18.9.6 Fixing the lathe slide
The cutting force occurring during facing, grooving or
cutting-off operations can cause the lathe slide to move.
Therefore fasten lathe slide with the fixing screw.
18.9.7 Turning between tips
Workpieces that require a high concentricity are
machined between the tips. A centre hole is
drilled in both face turned faces of the
workpiece. The turning heart is clamped onto
the workpiece. The driving pin, which is screwed
into the chuck flange, transmits the torque to
the rotary heart. The fixed centering point is
located in the centre hole of the workpiece on
the spindle head side. The rotating center point
is located in the centering hole of the workpiece
on the tailstock side.
18.9.8 Turning short taper with the top slide
The short taper is turned by hand with the top slide. The upper
slide is swivelled according to the desired angle. The infeed
takes place with the cross slide:
1. Loosen the two clamping screws at the front and rear of the
upper slide.
2. Turn the upper slide to the desired position.
3. Clamp the upper slide again.
Bekijk gratis de handleiding van Holzmann ED750FDQ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Holzmann |
| Model | ED750FDQ |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 33097 MB |
