Holzmann ED420FXL handleiding
Handleiding
Je bekijkt pagina 34 van 61
SAFETY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 34
ED420FXL_230V
• Shut down the machine and disconnect it from the power supply before carrying out any
adjustment, conversion, cleaning, maintenance or repair work. Before starting any work on
the machine, wait until all tools or machine parts have come to a complete standstill and
secure the machine against unintentional restarting.
• Do not work on the machine if it is tired, not concentrated or under the influence of
medication, alcohol or drugs!
• Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
12.5 Electrical Safety
• Make sure that the machine is grounded.
• Only use suitable extension cables.
• A damaged or tangled cable increases the risk of electric shock. Handle the cable with care.
Never use the cable to carry, pull or disconnect the power tool. Keep the cable away from
heat, oil, sharp edges or moving parts.
• Proper plugs and outlets reduce the risk of electric shock.
• Water entry into the machine increases the risk of electric shock. Do not expose the
machine to rain or moisture.
• The machine may only be used if the power supply is protected by a residual current circuit
breaker.
• Use the machine only when the ON-OFF switch is in good working order.
12.6 Special Safety Instructions for Lathes
• Clamp the workpiece firmly before turning on the lathe.
• Clamp the lathe tool to the correct height and as short as possible.
• Do not wear gloves when turning!
• Keep sufficient distance from all rotating parts.
• Switch off the lathe before measuring the workpiece.
• Remove the clamping key from the chuck after each tool change.
• Never remove any chips by hand! Use a chip hook, rubber wiper, hand brush or brush.
• When using cooling lubricants, observe the manufacturer's instructions and use a skin
protection agent if necessary.
12.7 Hazard Warnings
12.7.1 Residual risks
Despite intended use, certain residual risks remain when operating the machine.
• Formation of a flow chip
- This wraps around the forearm and causes severe cuts.
• Throwing away workpieces or tools at high speed.
- Always check workpieces for suitability and clamp them securely and firmly
- Clamp and center longer workpieces via an additional counter bearing (e.g. tailstock)
- For very long workpieces, use a steady rest
• Risk of electric shock if incorrect electrical connections are used.
• Risk of tripping due to supply lines on the floor.
- Properly route supply lines and cables
- Mark unavoidable tripping hazards yellow-black
Residual risks can be minimized if the "Safety instructions" and the "Intended use" as well as the
operating instructions are observed.
12.7.2 Hazardous situations
Due to the design and construction of the machine, hazardous situations may occur which are
identified as follows in these operating instructions:
DANGER
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Bekijk gratis de handleiding van Holzmann ED420FXL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Holzmann |
| Model | ED420FXL |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 14276 MB |
