Handleiding
Je bekijkt pagina 8 van 127
Very important
· The refrigerator will have better performance at ambient of 20-25
degree; We suggest the refrigerator be powered off if the ambient
temperature is lower than 10 degree.
· After plugging the appliance, allow the unit to cool down for 2-3
hours before placing beverage into the refrigerator compartment.
· Ventilation is very important for this kind thermoelectric
refrigerator; The inside PCB will be broken easily if the ventilation is
bad; It will also reduce the life of the refrigerator.
· The refrigerator applies automatic defrosting system, so there is
no need to defrost it manually.
Power supply
· The refrigerator must be connected to a properly earthed socket
in line with relevant valid country regulations before operating;
· Check the data label (which is on the side of the refrigerator) for
voltage and frequency corresponds to your local one; If not, don't
plug your cable into the socket;
WARNING: To avoid a hazard due to instability of the appliance,
it must be fixed in accordance with the instruction.
Installation instructions
When install a Heat pipe Refrigerator, ventilation should be
considered seriously, please refer to the following:
· There should be left at least 200 cm³ for ventilation
· The distance between wall and refrigerator side should be at least
20mm
· The bottom should be left at least 50mm for air flowing air passing
through must not be preheated
· Entire cooling system should be considered in the ventilation
· The following four pictures show four installation ways:
Bekijk gratis de handleiding van H.Koenig TOAD7, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | H.Koenig |
| Model | TOAD7 |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 10016 MB |