HK Audio SI SERIES P10J TR handleiding
Handleiding
Je bekijkt pagina 12 van 31
- 12 -
• English
Operating and Installation Instructions 1.0SI SERIES P10
4 Electrical connections
The following section describes how to make the electrical connections and how to mount the cover
plate.
Note: The manufacturer's specification of protection class IP 66 (EN 60529) for the
overall construction only applies if the instructions in this section are followed during
installation.
4.1 Electrical connections for P10i and P10j
Two 4-pole connectors are available for wiring the P10i and P10j. These always have two poles and are
electrically connected in parallel.
Before starting the cabling, the speaker cable (not yet stripped) must be pushed through the
opened PG gland of the enclosed cover plate. Further notes on mounting the cover plate in
4.3.
Only one conductor may be connected to each clamping point. It is not permissible to insert several
conductors into the same clamping point, as these are not designed for this and could become loose in
the long term.
As a general rule, we recommend that all connection cables be provided with (gas-tight) crimped wire
end sleeves to prevent the oxidation of the conductors in the long term. Non-crimped (bare) conductors
form an oxide layer in the long term, which worsens the contact resistance at the terminals.
In practice, it has proven useful to connect one connection cable per connector, because this makes
the actual assembly more convenient in confined spaces or when the cables are pulled in dierent
directions. However, all conductors can also be inserted to only one connector, as they are electrically
connected in parallel (as described above).
4.2 Electrical connections for P10i TR and P10j TR
For the wiring of P10i TR and P10j TR there are two 4-pole connectors available. These are wired to
100V or 70 V for the three power taps available.
Only one single conductor may be connected per clamping point. It is not permissible to insert several
conductors into the same clamping point, as these are not designed for this purpose and could become
loose in the long term.
To connect an additional loudspeaker, the second connector must therefore always be used
for P10i TR and P10j TR.
All further operating instructions from see 4.1.
4 Electrical connections
Bekijk gratis de handleiding van HK Audio SI SERIES P10J TR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | HK Audio |
| Model | SI SERIES P10J TR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4304 MB |
