Hitachi RAK-QH10PCBST handleiding

50 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 20 van 50
– 20 –
ATTACHING THE AIR PURIFYING FILTERS
1
Open the front panel
Pull up the front panel by holding it at both
sides with both hands.
2
Remove the Pre- lter
Push upward to release the claws and pull out
the Pre- lter.
4
Attach the Pre- lters
Attach the Pre- lters by ensuring that the surface
written “FRONT” is facing front.
After attaching the Pre- lters, push the front panel
at three arrow portions as shown in gure and
close it.
Before cleaning, stop operation and switch off the power supply.
CAUTION
!
!
CAUTION
Do not bend the air purifying
lter as it may cause damage
to the structure.
Please do not smell direct from
source of lter.
NOTE
In case of removing the air purifying lters, please follow the above procedures.
The cooling capacity is slightly weakened and the cooling speed becomes slower when the air purifying
lters are used. So, set the fan speed to "HIGH" when using it in this condition.
Air purifying lters are not washable. It is recommended to use vacuum to clean it. It can be use for
1 year time. Type number for this air purifying lter is <SPX-CFH22VR>. Please use this number for
ordering when you want to renew it.
Pre- lter
C-case xing slot
Air purifying lter
Insert the air
purifying lter
Claw
C-case
3
Attaching the air purifying lters
Attach the air purifying lters to the C-case
by gently inserting from the either side and
securely tted as shown in diagram. Do not
bend the frame or edge of the lters.
Bring the C-case to the back side of the pre-
lter. Insert it claws on left and right to the
C-case xing slot securely.

Bekijk gratis de handleiding van Hitachi RAK-QH10PCBST, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkHitachi
ModelRAK-QH10PCBST
CategorieAirco
TaalNederlands
Grootte6659 MB