Handleiding
Je bekijkt pagina 9 van 24
– 9 –
MAINTENANCE
CAUTION
!
1
2
3
1. PRE-FILTER
Clean the Pre-fi lter, as it removes dust inside the room. In case the Pre-fi lter is full of dust, the air fl ow
will decrease and the cooling capacity will be reduced. Further, noise may occur. Be sure to clean the
Pre-fi lter following the procedure below.
Open the front panel and remove the Pre-fi lter
● Gently lift and remove the air purifying fi lters
from the air purifying fi lter frame.
Vacuum dust from the Pre-fi lter and air purifying
fi lter using vacuum cleaner. If there is too much
dust, rinse under running tap water and gently
brush it with soft bristle brush. Allow fi lters to dry
in shade.
● Re-insert the air purifying fi lter to the fi lter frame.
Set the Pre-fi lter with “FRONT” mark facing front,
and slot them into the original state.
● After attaching the Pre-fi lters, push the front
panel at three arrow portions as shown in
fi gure and close it.
Before cleaning, stop operation and switch off the power supply.
!
CAUTION
● Do not wash with hot water at more than 40°C. The Pre-fi lters may shrink.
● When washing it, shake off moisture completely and dry it in the shade; do not expose it directly
to the sun. The Pre-fi lters may shrink.
● Do not use detergent on the Pre-fi lter as some detergent may deteriorate the Pre-fi lter electrostatic
performance.
Bekijk gratis de handleiding van Hitachi RAK-DH13PCBST, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hitachi |
| Model | RAK-DH13PCBST |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 3920 MB |
