Hisense HWEP8014 handleiding
Handleiding
Je bekijkt pagina 58 van 76
What to do?Indication on the display unit and
problem description
Problem/
Error
Check the following:Water filling error
• is the water inlet valve open,
• is the filter on the water inlet hose clean,
• is the water supply hose deformed
(clipped, clogged etc.),
• is the pressure in the water mains between
0.05 and 0.8 MPa (0.5–8 bar)
press the (3) START/PAUSE button to resume
the programme.
If the error reoccurs call a service technician.
Restart the program; if the error reoccurs, call
a service technician.
Water heating error
Check the following:Water draining error
• is the pump filter clean,
• is the drain hose clogged,
• is the drain clogged,
• if the discharge hose placed is placed
below the maximum and above the
minimum height (see chapter
»INSTALLATION AND CONNECTION/
Connecting and securing the water
discharge hose«);
press the (3) START/PAUSE button again.
If the error reoccurs call a service technician.
Too much detergent may cause excessive
foaming in the drum. See description for
Excessive amount of detergent
Turn off the washing machine and turn it back
on.
Inspect the exterior of the appliance. If you do
not observe any leaks, you can continue to
use the washing machine.
Water leak detected in the
washing machine area
Unplug the power cord from the outlet; then,
plug the power cord back into the outlet and
switch on the washing machine.
Vent the appliance. Do this by draining and
cleaning the washing machine filter and
cleaning the wall-mounted trap.
If the error reoccurs call a service technician.
Water level sensor error
58
Bekijk gratis de handleiding van Hisense HWEP8014, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hisense |
| Model | HWEP8014 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 5757 MB |
