Hisense Hi Move V handleiding
Handleiding
Je bekijkt pagina 27 van 120
DUST CONTAINER AND FILTERS
1
Dust container and filters
Remove the hose from the motor unit. // To clean the dust container, push the button on the bottom of the
container // The bottom of the dust container opens, and dust can be removed from the container. // To
remove the filter rim, rotate the rim and pull it out of the container. // To remove the filter, press the button on
the bottom part of the container (above the battery) // To remove the container from the motor unit, carefully
lift the dust container at an angle, as shown in the figure, so as not to damage the circuit. //Remove the filter
from the container and empty it. // The container, sleeve and filter can be wiped, shaken or rinsed with
lukewarm water, but be careful, as improper handling can damage parts of the vacuum cleaner. // Before
reinstalling the container back into the appliance, make sure that all parts are completely dry. //To install the
inner parts of the container, reassemble the vacuum cleaner correctly. // Never vacuum without the dust filter
inserted.
2
Replacing the filter
If you notice that the filter is damaged, replace it immediately. With regular use, we recommend replacing
the filter every 6 months to ensure the longest life of the vacuum cleaner.
DISPOSAL OF THE APPLIANCE
If you want to replace the appliance or no longer need it, you should also think about protecting the
environment.
The battery must be removed before disposing of the vacuum cleaner. // To safely remove the battery, make
sure that the battery is completely discharged. If the appliance does not have a removable battery, follow the
instructions given in the booklet with figures.
ERROR CODES
Error 1
The battery is running low and needs to be replaced.
Error 2
The NTC sensor has malfunctioned and requires either battery replacement or professional
repair.
Error 10
The suction motor signal wire is defective and needs to be repaired by a professional.
Error 11
The appliance is malfunctioning and requires professional repair.
Error 12
The operating current is too high or the bed brush and floor brushes are defective and need to
be repaired by a professional.
Error 13
The battery pack is not installed correctly, so it needs to be reinstalled – see quick guide for
battery installation. When the battery is installed, the OLED still displays an error and needs
to be repaired by a professional.
Error 14
The floor brush roller does not work when it is installed on the floor brush, and the floor brush
has a power-on fault and needs to be taken to a professional for repair.
Error 104
The charging current is too high, causing the charger to fail. The charger needs to be
replaced.
Error 105
The charging voltage is too high, causing the charger to fail. The charger needs to be
replaced.
Error 106
If the charging temperature is too high, wait 60 minutes before charging. If the error is still
showing, replace the charger.
Error 107
When operating the appliance at a high speed, if the temperature of the appliance or the
environment is too high, it is advisable to wait 60 minutes before resuming use.
Roller stuck
Check to see if any debris is blocking the airflow into the hose. Consult the quick guide for
proper removal of the roller. Detach the roller from the brush and clean the brush. Check that
there is no more debris in the hose.
Error 109
The charging time of the charger exceeds 6 hours, indicating a failure, and replacement of
the charger is required.
Error 110
Suction motor overvoltage protection. Must be sent to qualified professionals for repair.
Error 111
Suction motor overcurrent protection. Must be sent to qualified professionals for repair.
Error 112
Suction motor overheat protection, resulting in automatic shutdown of the appliance. Must be
sent to qualified professionals for repair.
Air flow
blocked
When operating the appliance at a high speed, the motor has exceeded its optimal speed.
The hose is blocked. // The filter is blocked. // Note: ensure that the filter screen, filter and
dust container are dry-assembled before use.
Error 120
If the filter and dust container are removed, the vacuum cleaner will not operate.
27
Bekijk gratis de handleiding van Hisense Hi Move V, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hisense |
| Model | Hi Move V |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 13309 MB |
