Handleiding
Je bekijkt pagina 22 van 32
21
TROUBLESHOOTING TABLE
During the warranty period, only a service center authorized by the manufacturer may carry out any repairs.
Before making any repairs, make sure the appliance is disconnected from the power mains either by removing the fuse
or by disconnecting the power plug from the wall outlet.
Unauthorized tampering with and repairs of the kitchen range (cooking hob) can result in electric shock or short circuit;
hence, do not attempt to perform any repairs by yourselves. Leave such tasks to an expert or an authorized service
unit.
In case of minor faults or problems with the appliance operation, check the following instructions to see whether you
can eliminate the causes by yourselves.
Following is some advice on rectifying some common problems.
OVEN
Problem/error
Cause
There is no response of the sensors;
the display is frozen.
Disconnect the appliance from the mains power for a few minutes (undo
the fuse or switch off the main switch), then, reconnect the appliance and
switch it on.
The main fuse in your home trips
often.
Call a service technician.
Make sure the power of all appliances switched on does not exceed the
capacity of the power mains in your home.
The oven lighting does not work.
The process of changing the light bulb is described in the chapter
"Cleaning and Maintenance".
The food is underdone . . .
Did you choose the right temperature and heating system?
Is the oven door closed?
COOKING HOB
Error and fault display on
the cooking hob
Cause
Solution
You have switched on the
cooking zone, but the "u"
symbol continues to flash.
The pot or pan is not suitable for
induction hobs, or its diameter is too
small. Perhaps the pot or pan
overheated and lost its ferromagnetic
properties.
Check if the cookware is
ferromagnetic (if a magnet is attracted
to it). Make sure the pan diameter is
large enough (usually > 12 cm).
If the display continues to flash after
switching on and off, disconnect the
appliance from the power mains. Wait
for 5 minutes and reconnect it.
The Power Boost rapid
heating function is switched
off automatically.
It is normal for the Power Boost
function to be switched off
automatically after a certain period of
time and for the hob to switch to power
level 9. If the cooking zone is
overheated, the safety mechanism
will switch off the extra power function!
Reactivate the Power Boost function.
If necessary, switch off the cooking
zone and reconnect it. Then, activate
the Power Boost function. Wait for a
while for the hob to cool down.
Continuous beep and »–«
flashing on the display.
Water spilt over sensor surface, or an
object placed over the sensors.
Wipe the sensor surface.
»r« on the display
This indicates that the desired power level cannot be set because the limit for
maximum total cooking hob power has been activated.
»F« on the display
This indicates that there has has been an error during operation.
Error message "C" appears
on the display unit.
The hob has overheated.
Wait for the hob to cool down. Then,
use a lower power setting.
If the problems persist despite observing the advice above, call an authorized service technician. Repair or
any warranty claim resulting from incorrect connection or use of the appliance shall not be covered by the
warranty. In this case, the user will cover the cost of repair.
Bekijk gratis de handleiding van Hisense H2CI8617WB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hisense |
| Model | H2CI8617WB |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4246 MB |
