Hilti SPN 6‑22 handleiding
Handleiding
Je bekijkt pagina 21 van 72
*2331867*
2331867 14
7.Grease the guide surfaces of the punch guide.
8.Tighten the securing screws to the specified torque in diagonally opposite sequence.
Technical data
Tightening torque 3 Nm
(2 ftlb
f
)
Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected
from excessive shock and vibration and isolated from any conductive materials or other batteries
that may come in contact with the terminals and cause a short circuit. Comply with the locally
applicable regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship
undamaged batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits
stated in the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the
charging operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized
persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed
Status indicators of the Liion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem
by yourself, contact Hilti Service.
Trouble or fault Possible cause Action to be taken
The battery runs down
more quickly than usual.
Very low ambient temperature. ▶ Allow the battery to warm up
slowly to room temperature.
The battery does not en-
gage with an audible click.
The retaining lug on the battery
is dirty.
▶ Clean the retaining lug and
re-insert the battery.
Bekijk gratis de handleiding van Hilti SPN 6‑22, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hilti |
| Model | SPN 6‑22 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6307 MB |
