Hikoki R18DA handleiding
Handleiding
Je bekijkt pagina 20 van 60
English
20
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not
remedy the problem, consult your dealer or the HiKOKI Authorized Service Center.
Symptom Possible cause Remedy
Tool doesn’t run No remaining battery power Charge the battery.
Tool suddenly stopped Tool was overburdened Get rid of the problem causing the
overburden.
The battery is overheated. Let the battery cool down.
Poor suction Dust case is full. Dispose the dust.
Nozzle is plugged. Remove the obstruction.
Nozzle or extension pipe is loose. Firmly tighten the unit.
Nozzle or extension pipe is
cracked or damaged.
Exchange the unit with a new one.
Filter or pre fi lter is clogged. Turn the dust case and scrape
off dust with dust removal blade,
or remove the fi lter/pre fi lter and
lightly strike it or wash with water.
Exhaust or the main
unit is hot
The motor is overheating because
the dust case is full, or the fi lter/
pre fi lter is clogged.
Dispose the dust. Or else, clean
the fi lter/pre fi lter.
Abnormal noise/foul
odor
Filter or pre fi lter in not properly
installed, resulting in foreign
matter getting into the motor.
Remove the dust case, point the
intake port downward and gently
shake to remove foreign matter
and dust.
Should abnormal noise/foul
odor persist, the motor may
be damaged. Immediately
discontinue use and arrange for
repairs.
000BookR18DAChS.indb20000BookR18DAChS.indb20 2018/04/279:42:052018/04/279:42:05
Bekijk gratis de handleiding van Hikoki R18DA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hikoki |
| Model | R18DA |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10895 MB |
