Hikoki R18DA handleiding
Handleiding
Je bekijkt pagina 12 van 60
English
12
NOTE
The recharging time may vary according to temperature and power source voltage.
CAUTION
When the battery charger has been continuously used, the battery charger will be
heated, thus constituting the cause of the failures. Once the charging has been
completed, give 15 minutes rest until the next charging.
4. Disconnect the charger’s power cord from the receptacle.
5. Hold the charger fi rmly and pull out the battery.
NOTE
Be sure to pull out the battery from the charger after use, and then keep it.
Regarding electric discharge in case of new batteries, etc.
As the internal chemical substance of new batteries and batteries that have not been used
for an extended period is not activated, the electric discharge might be low when using
them the fi rst and second time. This is a temporary phenomenon, and normal time required
for recharging will be restored by recharging the batteries 2 – 3 times.
How to make the batteries perform longer
(1) Recharge the batteries before they become completely exhausted.
When you feel that the power of the tool becomes weaker, stop using the tool and recharge
its battery. If you continue to use the tool and exhaust the electric current, the battery may
be damaged and its life will become shorter.
(2) Avoid recharging at high temperatures.
A battery will be hot immediately after use. If such a battery is recharged immediately after
use, its internal chemical substance will deteriorate, and the battery life will be shortened.
Leave the battery and recharge it after it has cooled for a while.
CAUTION
○
If the battery is charged while it is heated because it has been left for a long time in
a location subject to direct sunlight or because the battery has just been used, the
pilot lamp of the charger lights for 1 second, does not light for 0.5 seconds (off for
0.5 seconds). In such a case, fi rst let the battery cool, then start charging.
○
When the pilot lamp fl ickers (at 0.2-second intervals), check for and take out any
foreign objects in the charger’s battery connector. If there are no foreign objects, it
is probable that the battery or charger is malfunctioning. Take it to your authorized
Service Center.
○
Since the built-in micro computer takes about 3 seconds to confi rm that the battery
being charged with charger is taken out, wait for a minimum of 3 seconds before
reinserting it to continue charging. If the battery is reinserted within 3 seconds, the
battery may not be properly charged.
○
If the pilot lamp does not blink in red (every second) even though the charger cord
is connected to the power, it indicates that the protection circuit of the charger may
be activated.
000BookR18DAChS.indb12000BookR18DAChS.indb12 2018/04/279:42:032018/04/279:42:03
Bekijk gratis de handleiding van Hikoki R18DA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hikoki |
| Model | R18DA |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10895 MB |
