Heylo FT 500 handleiding

Handleiding

12345678910111213141516171819202122/ 22

Afdrukken

Je bekijkt pagina 15 van 22

15

EN

Assembly DCD-3.0

If required the closing caps (E) should be removed before

assembly (removal is not possible after assembly of the

DCD!)

Hold the unit tight with the right hand on the holding grip (F) at

the back and with the left hand on the tightening knob (G).

The tightening lever (G) is then fitted at 90° to the unit. The

system has now been loosened and can be roughly adjusted

in the door. The side with the tightening lever points

towards the black are during this procedure.

The unit is fixed tightly into the door by tightening the

tightening knob (G).

The PVC sheets (H) supplied with the unit are now attached

in line with the door width to the DCD. The first PVC-sheet H

is now being fixed to the adhesive and pushed behind the

fastening clamps (J), then clamped tight using the knurled

screw (K). After this clamp the second sheet overlapping

roughly 20 cm, also behind the fastening clamps (J).

If necessary, both sheets (Length, 2 m) can be shortened with

a cutter.

Now – depending on the use (see Section 5) – one or two

hoses (Ø 203 mm) can be drawn through the openings of the

DCD.

E

E

F

G

H

J

K

12345678910111213141516171819202122/ 22

Bekijk gratis de handleiding van Heylo FT 500, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Gerelateerde producten van Heylo (Niet gecategoriseerd)

Handleiding bekijken

Heylo StaubStop 3000

Niet gecategoriseerd - handleiding

Andere merken in Niet gecategoriseerd