Handleiding
Je bekijkt pagina 5 van 24
©2021 Hestan Commercial Corporation
5
EN
ORIFICE LOCATIONS - RANGETOP SECTION
Shown below is a typical burner layout. The dual-flow rear burners have 15500 BTU output, while the
dual-flow front burners are 23000 BTUs. The center single-flow burner (if equipped) has a 30000 BTU
output (or 23000 on LP gas).
TYPICAL BURNER LAYOUT
(KRT365 SHOWN)
15.5k 15.5k
23k 23k
30k
The following pages describe how to replace the orifices in each burner type and each valve type. Do
one item at a time so as not to mix up orifices. All orifices must be fully seated and hand-tight to
reduce the chances of a gas leak. DO NOT USE any sealant, pipe dope, teflon tape, or anything else
on the orifice threads.
ABOUT HOSES: If you need to disconnect any hoses during this process, use caution to avoid
unnecessarily bending, twisting, or kinking any hoses. Hoses are stainless steel flex type which can
become brittle with age and can crack if handled roughly. Disconnect the fitting carefully where
necessary. You will perform a complete gas leakage test at the end of this procedure. If you feel
there is a good chance a hose will crack, do not begin this process unless you have replacement hoses.
All parts are available by contacting Hestan Customer Care.
Bekijk gratis de handleiding van Hestan KRG484GD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hestan |
| Model | KRG484GD |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 13468 MB |