Handleiding
Je bekijkt pagina 8 van 56
8
EN
5.1 CONNECTING THE CABLE
Loosen the screws fixing the left side of the oven
and extract it.
The oven must be connected to the electricity with
a rubber cable.
WARNING: the yellow/green voltage wires in the
earth cable must be 3 cm longer than the others.
The appliance has terminal strips such as those in
the diagram. To connect to the electricity, see the
label in the manual and stuck to the bottom of the
back of the device beside the information plate.
The appliance has terminal strips such as those in
the diagram. To connect to the electricity, see the
label in the manual and stuck to the bottom of the
back of the device beside the information plate.
Proceed as follows to connect the power supply
wire to the terminal board:
• (A1) Loosen the tops of the cable gland and open
the bottom part of the back of the appliance by
loosening the screws.
• (A2) Feed the new cable through the cable gland.
Connect the cable voltage to the terminal strips
following the connection diagram on the label
on the back of the appliance. Only connect what
is indicated inserting the copper bridge and the
electricity cable together under the screws, in
the tightening direction, so the cable and the
bridge are tightly fixed by tightening the screw.
The type of cable to be used is indicated on the la-
bel
for each connection and the voltage sections
in mm².
• (A4) Close the bottom part of the back of the ap-
pliance by tightening the screws and fit the cable
by tightening the cable gland top.
A1
A3
A2
A4
Bekijk gratis de handleiding van Hendi 223659, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hendi |
| Model | 223659 |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 5773 MB |
