Hendi 223659 handleiding

56 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 10 van 56
10
EN
Check that all the connections are tight before con-
necting the oven to the mains.
WARNING: Erroneous connection could lead to
overheating of the terminal board which could
lead to blowout and electric shock.
Check there is no static discharge between live and
earth. Check the limit switch continuity between
the external casing and the earth wire of the mains.
It is advised to use a multi tester to carry out these
operations
5.3 EQUIPOTENTIAL CONNECTION
This connection shall be carried between the dif-
ferent appliances with the terminal marked by the
symbol: .
This terminal enables the connection of Yellow/
Green cable with a section between 2.5 and 10 mm².
The appliance shall be included in an equipotential
system whose efficiency shall be duly verified ac-
cording to the provisions of the laws in force.
6. WATER CONNECTION
Make sure the device is placed near a water con-
nection. Before connecting the device, allow enough
water through to remove any remnants in the piping
so that they did not get into the magnetic valves. It is
necessary to install a shut-off valve and mechanical
filter between the plumbing and the device.
On the back of the device, in the area marked with
a label, the convection oven has an input G 3/4” with
a filter. The inflowing water shall have a pressure
value comprised between 150 (1,5 bar) and 200 kPa
(2 bar) and a maximum temperature of 30°C. If the
inflow pressure value exceeds 200 kPa (2 bar),
a pressure reducer will have to be installed, cali-
brated at 200 kPa (2 bar).
6.1 WASHING WATER CONNECTION
A shut-off valve and a mechanical filter must be
placed between the mains water supply and the
oven. The rear of the oven has a G 3/4” inlet with
pipe.
ATTENTION: Before connecting the appliance to
the mains water supply, rinse with water to elimi-
nate any residue. To guarantee proper operation of
the cleaning system, the mains water supply pres-
sure must be a minimum of 200 kPa (2 bar) and the
temperature must not exceed 30°C. Lower water
pressure values may prevent the cleaning system
from working properly.

Bekijk gratis de handleiding van Hendi 223659, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkHendi
Model223659
CategorieOven
TaalNederlands
Grootte5773 MB