Helix V EIGHT DSP ULTIMATE handleiding
Handleiding
Je bekijkt pagina 23 van 36
23
en
ommend setting all 6 jumpers to the „High
Voltage Range“ (Line 2 - 8 V / Highlevel 8 -
32 V) to avoid potential damage to the de-
vice. To do this, the jumpers must be moved
to the factory-unused multi-pin connectors,
as shown in gure 2.
c. Place the jumpers in the corresponding
voltage range
To change the position of a jumper, simply
lift it upwards and insert it into the desired
position. Ensure that the jumper is fully in-
serted and not oset.
Overview jumper plug-in positions:
Low voltage range conguration
( by default / see g. 1):
Value range: Highlevel 4 - 16 Volts
Line (RCA) 1 - 4 Volts
High voltage range conguration
(see g.2):
Value range: Highlevel 8 - 32 Volts
Line (RCA) 2 - 8 Volts
Figure 1:
Figure 2:
d. Reassemble the amplier
2. Connecting the line inputs
These six lowlevel line inputs (LINE INPUT)
can be connected to signal sources such as
head units / car radios or factory installed
ampliers using appropriate cables. Each in-
put can be assigned to any output using the
DSP PC-Tool software. Input sensitivity is fac-
tory-set to 2.8 Volts for all channels. But it is
possible to optimally adapt the input sensitivity
to the signal source using the DSP PC-Tool
software (see page 25, point 8).
The automatic turn-on circuit does not work
when using the line inputs. In this case the
remote input (REM) has to be connected to
activate the HELIX V EIGHT DSP ULTIMATE.
Important: It is strictly forbidden to use the
highlevel speaker input and lowlevel line input
of an individual channel at the same time as
this may cause severe damage to the con-
nected signal source. Nevertheless it is pos-
sible to use the highlevel input of one channel
and the lowlevel line input of another channel
simultaneously.
3. Connecting the highlevel speaker inputs
The 12 highlevel speaker inputs (HIGHLEV-
EL INPUT) can be connected directly to the
loudspeaker outputs of an OEM, aftermarket
radio or factory installed amplier using appro-
priate cables (loudspeaker cables with 1 mm²
/ AWG 18 max.).
We recommend the following channel assign-
ment if a common car radio will be connected
to the amplier:
Channel A = Front left
Channel B = Front right
Channel C = Rear left
Channel D = Rear right
Actually it is not mandatory to use all high level
speaker inputs. If only two channels will be
connected we recommend to use the chan-
nels A and B. Make sure that the polarity is
correct. If one or more connections have re-
versed polarity it may aect the performance
of the amplier. If this input is used the remote
input (REM) does not need to be connected
as the amplier will automatically turn on once
a loudspeaker signal is received.
Bekijk gratis de handleiding van Helix V EIGHT DSP ULTIMATE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Helix |
| Model | V EIGHT DSP ULTIMATE |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7386 MB |
