Helix AMPLIFY 204 X-OVER handleiding
Handleiding
Je bekijkt pagina 19 van 24
19
en
1. Crossover frequency control (FREQ)
These controls allow you to set the crossover
frequency of the high- or lowpass lter of each
channel pair (A/B or C/D) between 45 and
400 Hz. These controls are activated when
the respective X-Over switch is set to “LPF” or
“HPF” (page 17, point 6).
2. Status LED
The Status LED indicates the operating mode
of the amplier.
Green: The amplier is ready for operation.
Red: Protection Mode active. A malfunction
has occurred that may have dierent root
causes. The amplier is equipped with protec-
tion circuits against over- and undervoltage
as well as overheating. Please check for con-
necting failures such as short-circuits or other
incorrect connections. If the amplier is over-
heated, the internal temperature protection
will turn o the signal output until it reaches a
safe temperature level again. If the amplier
does not turn on, it is defective and needs to
be sent to your local authorized HELIX dealer
for repair service.
Additional functions
Bekijk gratis de handleiding van Helix AMPLIFY 204 X-OVER, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Helix |
| Model | AMPLIFY 204 X-OVER |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2988 MB |
