Heinner HPM-1300WHBK handleiding
Handleiding
Je bekijkt pagina 4 van 28
www.heinner.com
3
(1) Turn the “Head release switch” clockwise for 90°to make the head stay at the release status, then lift the
head upwards until it is locked well in position.
(2) To install the accessory onto the lower output port, firstly make the groove of the accessory align with
the fixing pin of the lower output port shaft and then insert the accessory into the lower output port, then
push the accessory upwards and rotate it clockwise to fix the accessory onto the fixing pin of lower output
port shaft (see Fig.1).
To detach the accessory, firstly push the accessory upwards and then rotate it anticlockwise, then remove it
out of the lower output port.
NOTE: The accessory must be completely locked onto the lower output port, otherwise, it may fall off during
operation to cause risk.
Place the bowl on the base and rotate it clockwise to fix it well in position (see
(4) Turn the “Head release switch” clockwise for 90°to make the head stay at the release status, then press
the head downwards until it is locked well in position
(5) Place the bowl lid onto the steel bowl.
OPERATION INSTRUCTION
Dough hook/Beater/Whisk
1. Follow the above operation to install the desired accessory onto the lower output port.
Before assembling, make sure that the appliance is unplugged, and the speed knob is turned
to the "0" position.
2. Add the ingredients required into the steel bowl, refer to the section of “RECIPES” for the detail of
ingredients.
3. Connect the appliance with power source.
4. Select the desired speed by the speed knob. There are ten speeds for selection. After selecting the desired
speed, the appliance starts to run at the selected speed.
WARNING: Do not insert the knife, metal spoon or fork into bowl during working.
NOTE: The maximum working time per time shall not exceed 10 minutes and minimum 30-minute rest time
must be maintained between two consecutive cycles. When kneading dough, suggest selecting the speed 1
for kneading for 30 seconds to 1 minute firstly, and then select the speed 2 for kneading for 4-5 minutes to
obtain a better kneading result.
NOTE: During kneading, some flour may be adhered on the inside of the bowl, you shall firstly turn the speed
knob to “0” position and then unplug the appliance, then remove the bowl cover, scrape the flour on the
inside wall of bowl by a spatula, finally, operate the appliance again.
NOTE: Ingredients can be added through the opening of the steel bowl lid during working.
5. After finish working, turn the speed knob to “0” position and then unplug the appliance.
6. Remove the bowl lid, turn the “Head release switch” clockwise for 90°to make the head stay at the release
status and then lift the head upwards until it is locked well in position.
7. Scrape the food adhered on the accessory by a spatula.
Bekijk gratis de handleiding van Heinner HPM-1300WHBK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Heinner |
| Model | HPM-1300WHBK |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6041 MB |
