Handleiding
Je bekijkt pagina 6 van 81
www.heinner.com
5
Wiring diagram
WARNING: The electrical connection of the product must be done by authorized and certified personnel. The
manufacturer shall not be held responsible for damage that may arise due to the operations performed by
unauthorized people.
WARNING: Have an authorized electrician set grounding equipment. The manufacturing company will not
be responsible for the damage that may occur due to using the product without grounding according to local
regulations.
RISK OF ELECTROCUTION: Before conducting any operation on the electrical wiring, remove the electrical
connection of the appliance.
Make the electrical connection of your oven according to the appropriate wiring diagram.
Power supplies vary according to the electrical power that is used by the appliance. You can acquire the
electrical power of the appliance by looking at the type of label on the appliance's rear hood. The following
table should be considered during the power supply change.
Power
range
Feeding cord type and size
1380-2299 W
H05VV-F 3G 1.0 mm²
Gas connection
RISK OF EXPLOSION: Before starting any work related to gas installation, turn off gas supply. Risk of
explosion.
WARNING: All kinds of work to be performed on gas equipment and systems should be carried out by
authorized and qualified people. The manufacturer shall not be held responsible for damage that may arise
due to the operations performed by unauthorized people.
WARNING: Check if the appliance settings are compatible with the local distribution conditions (gas type and
gas pressure) before placing the appliance.
The product does not have exhaust. For this reason, this product should be installed according to installation
regulations in force. Conditions regarding ventilation should be considered.
Use the product on a flat surface and in a well-ventilated environment.
Gas hose crossing path
Make sure that the appliance’s gas pipe and power cable do not pass by the hot surfaces.
Connect your appliance to the gas mains cock in the shortest way and without any leakage.
WARNING: Hose types must comply with EN 1762 standard for LPG and EN 14800 standard for NG.
WARNING: The hose which is used for safety should be at least 50 cm and at most 125 cm.
WARNING: Do not move a gas connected appliance. Any force may cause gas leakage as it may loosen the
hose.
LPG connection
Attach the metal clamp to the hose coming from the LPG cylinder. Install one end of the hose by pushing it
all the way to the hose inlet fitting on the back of the appliance by heating it in boiling water. Tighten with a
Bekijk gratis de handleiding van Heinner HFSC-S66FDC-BIX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Heinner |
| Model | HFSC-S66FDC-BIX |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 17897 MB |
